Product Data Sheet (PDF)

Material Safety Data Sheet (MSDS)

DIRECTIONS FOR USE

Surface preparation:
Carefully brush off all dust and debris. Ensure surfaces to receive PENEBAR^TM PRIMER are free from all types of curing agents, oil and grease.

Installation:
Using a brush apply PENEBAR^TM PRIMER in a stripe with a minimum width of 2" (51 mm), at a minimum thickness of 4 mils (0.1 mm) and to the entire surface length to receive PENEBAR^TM SW.
Allow PENEBAR^TM PRIMER to dry for 10 to 15 minutes at a temperature of 77°F (25°C) or longer when the temperature is lower.
While PENEBAR^TM PRIMER is still tacky, install PENEBAR^TM SW by firmly pressing the entire length of the preformed joint sealer onto the primer. For vertical and overhead applications, press firmly for at least 10 seconds.
PENEBAR^TM SW should be installed while PENEBAR^TM PRIMER is tacky and within 3 hours after the primer has dried. If PENEBAR^TM SW is not installed within 3 hours, reapply an additional coat of PENEBAR^TM PRIMER.