Call Us
85612441
Email Us
info@penetronph.com
Address
Antipolo City 1870
Call Us
85612441
Email Us
info@penetronph.com
Address
Antipolo City 1870
DESCRIPTION : PENEBARTM SW-55 is a waterstop developed to stop water penetration through cast-in-place concrete joints by expanding in a controlled fashion when exposed to water and making a positive seal inside and against the concrete. Its superior ability to expand and seal concrete joints allows it to replace the more passive tied in PVC waterstop systems and eliminate welding irons, split-forming and special shapes.
PENEBARTM SW-55 can be applied to non-
moving, concrete construction joints for both
horizontal and vertical applications. It can be
used on new or existing concrete, irregular
surfaces and through-wall or slab penetrations,
such as pipes, utility lines, piling and steel
members.
Other typical applications that are ideal for
PENEBARTM SW-55 are: underground struc-
tures, basements, precast panels, tunnels,
manholes, lift pits, retaining walls, concrete pipe
and storage tanks.
DIRECTIONS FOR USE
1) Apply PENEBARTM PRIMER by using brush at a minimum of 0.1 mm (4
mils) thick by 25 mm (1”) wide over the entire surface length to receive
PENEBARTM SW-55. Allow it to dry for 10-15 min at a temperature of 25°C
(77°F), or where the temperatures are low, allow it dry for longer time.
2) By using the heel of the hand and moderate pressure, press a bead of
PENEBARTM SW-55 firmly into position on the standing structure. Make
sure the product has bonded with the primed area.
3) Where required, splice ends to form a continuous, uninterrupted seal.
For best results, cut each end at opposite 45° angles and tightly butt ends
together. DO NOT OVERLAP ENDS. Gently knead the spliced ends creating
an uninterrupted seal.
4) Peel the protective covering from the exposed side of the installed
PENEBARTM SW-55.
5) Follow standard concrete placing procedures from here onwards.